Why won’t My Brother sewing machine pick up the bobbin thread?

How do I get my brother sewing machine to pick up the bobbin thread?

With your right hand, turn the balance wheel toward you (counterclockwise) until the needle moves down and back up again to its highest position. The upper thread should have caught the lower thread in a loop. Pull the upper thread toward you and the lower thread will come up from the bobbin in a large loop.

Why is my bobbin threader not working?

Check if you aligned the groove in the bobbin with the spring on the bobbin winder shaft and pressed down on the bobbin until it snapped into place. Check if the thread is passed through the bobbin winding guide correctly. Check if there are scratches or other defects on the bobbin. Replace the bobbin if in doubt.

Why is my thread bunching underneath?

A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.

What is the correct tension for a Brother sewing machine?

The normal tension setting is 4.0. The upper thread and the bobbin thread should cross near the center of the fabric. Only the upper thread should be visible from the right side of the fabric, and the bobbin thread should be visible from the wrong side of the fabric.

IT IS INTERESTING:  Do sewing needles hurt?

How do I reset my Brother sewing machine?

FAQs & Troubleshooting

  1. Press. [Settings]>[All Settings]>[Initial Setup]>[Reset]. …
  2. Swipe up or down or press or. to display the type of reset functions, and then press the reset function you want to use. …
  3. [Machine will reboot after resetting. Press [OK] for 2 seconds to confirm.] …
  4. Press .

What does e1 mean on a Brother sewing machine?

The foot controller was pressed (or the start/stop button was pressed if the foot controller is not connected) and the reverse/reinforcement stitch button was pressed while the presser foot is raised. Lower the presser foot lever before continuing the operation.