Why are my stitches loose on one side?

Why are my sewing stitches uneven?

The Problem: Stitches are coming out uneven or skipping entirely. THE SOLUTION: Odds are, the secret culprit here is a needle that is broken, bent, or otherwise damaged. Experts recommend that you replace your needles for every 16 hours of stitching time.

Why is my bottom stitch so loose?

Probable Causes: – Top or bobbin thread is not set correctly. – Make sure that the bobbin was threaded properly in the shuttle race. …

Why is my bottom stitch loose?

A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.

Why is my bottom stitch not straight?

If your thread is pulled tight on the underside and not forming an even stitch then (counter-intuitively) it’s usually the top thread tension that’s wrong. Sometimes very lightweight fabrics such as sheers can get dragged down into the machine so it’s a good idea to use a straight stitch plate.

IT IS INTERESTING:  How do you put leather soles on a knitted slipper?

Why does my sewing machine keep jamming underneath?

However certain you are that the problem with the machine is most likely due to a huge tangled mess of thread in the bobbin underneath the fabric, the most common reason for the jamming is usually the lack of sufficient tension in the upper thread.

What is the best stitch length for machine quilting?

For straight stitching, it is advised to set your machine’s stitch length to 2.5 to 3.0 or about 8-12 stitches per inch. This range works quite well for a majority of machine quilting but there are always exceptions when you make a rule. For threads with sparkle or shine, use a longer stitch length.

Why are my stitches different sizes?

When the bobbin case is threaded wrong, the upper thread and the lower one do not work in sync, forming uneven stitch or uneven feed among layers of fabric. Check the bobbin case and re-thread if needed. The thread should pass through the thread side slot in the case before being brought up to the needle.

How do I know if my bobbin tension is correct?

The thread should unwind just slightly and the bobbin case should drop an inch or two. If the thread unwinds without resistance and the case slips to the floor, your bobbin tension is too loose. If the bobbin case doesn’t budge, your bobbin tension is too tight.