How do you fill a bobbin on a sewing machine?
- Place spool of thread on spool pin. …
- Pass thread end, from inside, through the small hole in the rim of the bobbin (illustration 2).
- Place bobbin onto the pin. …
- Holding thread end, step on speed controller to run the machine until the desired amount of thread is wound. …
- Trim thread ends from top of the bobbin.
Why is my bobbin thread not catching?
Check the upper thread. – Check to see if your upper tension is too tight. … – Your thread could be caught on something between the needle and your spool of thread if so, your thread will be too tight for the needle to pick up the bobbin thread. – Make sure that the upper thread is threaded properly.
Why does my sewing machine keep getting jammed?
If your bobbin is threaded wrongly, it could cause jamming issues to your sewing machine. Your bobbin thread won’t move properly if there are knots or if the bobbin isn’t properly wound. Check to see if the threading on your bobbin is all tangled, and fix it if you can.
How much thread do you put on a bobbin?
Unwind about 18″ or so of thread and bring it around the backside of the bobbin winder tension disc, wind it around the tension disc one time. Some machines might have a thread guide before this step- if yours does, don’t skip it! Be sure to place your thread through all the thread guides on your machine.
What is a bobbin thread?
When sewing with a machine, the thread wound around the bobbin links with the upper needle thread to form the bottom part of a stitch. Typically used in machine embroidery, quilting, and sewing fine fabrics, bobbin thread is lightweight and strong, adding little bulk while still securing stitches.
Why does my bobbin thread show on top?
If the bobbin thread is on top, that means the top thread is pulling more, or, has more tension. That means either the top thread is too tight or the bobbin thread is too loose.
Why is my thread bunching underneath?
A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.