What does a bead reamer do?

How do you widen beads without a reamer?

You don’t have to purchase a bead reamer. A few things you can use: a safety pin, a toothpick, a paper clip or bobby pin, darning needle, anything with a point that will slide through the beading hole easily.

Can you use a bead reamer on gemstones?

This hand tool comes with a selection of tapered, diamond-coated tips to accommodate different-size bead holes. They work well for enlarging and smoothing the holes in gemstone, shell, pearl, and glass beads. To use one, hold your bead in one hand and the reamer in the other hand.

How do you enlarge a pearl hole?

However, if you’d like to use needle and thread again for your next design, use a pearl reamer to make the drill holes larger. These handy tools come with a very fine, tapered, corkscrew-like tip. Just pass the tip through the drill hole, hold onto the pearl and slide it back and forth to enlarge and smooth the hole.

How do you clean bead holes?

A bead reamer and water can clean out the release inside glass beads. Fill a shallow bowl with water and put on safety glasses. While holding the bead under the water, insert the reamer into the hole of the bead then carefully move the reamer with a quick up and down motion.

IT IS INTERESTING:  What does flat weave mean?

How do you enlarge a hole in glass?

Take a really small screwdriver that can fit in the hole already and put it in. Then slowly push the hole outwards to make it bigger and every once in a while heat the glass up again if it cools down too much to push it outwards…

How do you measure bead hole?

For beads that are a briolette, teardrop or melon shape – the length is used as a measurement from the top to the bottom (perpendicular to the string/cord) of the bead and the width is measured from one end of the bead hole to the other (parallel to the string) from the widest part of the bead.

How big is a bead hole?

Holes are usually 0.5mm, although the smallest pearl will be drilled at 0.3mm and some larger pearls may be upto 0.6mm. Larger diameter of silk thread will pull through a smaller hole.

What does it mean to ream a hole?

A reamer is a type of rotary cutting tool used in metalworking. Precision reamers are designed to enlarge the size of a previously formed hole by a small amount but with a high degree of accuracy to leave smooth sides. … The process of enlarging the hole is called reaming.